1. The motor does not run after the machine chip remover is first installed and switched on.

Solution: Check whether the input voltage of the motor power is normal and whether there is a virtual connection.

2. Motor idles, conveyor chain plate does not run.

Solution: To extend the service life of the motor, a protector is used on the reducer. Open the chain box and gently tighten the protector screw until the conveyor chain runs (Note: It is strictly prohibited to tighten the protector screw too much, otherwise the protector will lose the function of protecting the motor).

3. The chain of the long-used machine tool chip eliminator appears to be stretched and loose.

Solution: according to the actual situation to adjust the shaft adjusting bolts until normal.

4. In the process of chip removal, shell or debris gets stuck in the chain and cannot be operated.

Solution: If this problem occurs, it is necessary to immediately stop the work of the machine tool chip eliminator to remove the debris stuck into the chain plate and consult