Chip removal chain plate is broken.

This situation is mainly due to the chain plate overload, and the deceleration motor is still running normally caused by the damage. The main countermeasures are to relax the mechanical overload protector so that it can work normally. In case of overload, the overload protector slides without breaking the chain plate. Another way is to add an electronic overload protector, set a normal range of current, when the current is greater than this value, the breaker is disconnected, so as to protect the chain plate not to break.

Iron filings are often stuck and cannot be discharged normally.

The occurrence of this kind of circumstance basically is because the iron filings of spiral form is too long, sometimes an iron filings can reach 3-5 meters, filar silk again and again, accumulate more cause jam more. The main countermeasures of the machine tool chip removal machine have a general chain plate after the Angle of the place must be made of arc shape, not a stiff Angle, so that is conducive to the discharge of iron filings; In addition, the lower part of the chip removal mouth with a chip baffle plate, to prevent iron involved in the chain plate caused by the lower stuck.

The deceleration motor often burns out and its service life is too short.

Generally speaking decelerate normal service life in 3-5 years, compare leather solid. But there are also some cases of frequent damage, the main countermeasures include the installation of electronic overload protector, motor damage is mainly due to the current is too large, motor overload operation for a long time caused by the motor overheating, but also to pay attention to the power of the motor and the machine tool chip removal machine must match, such as the power is too small is one of the causes of easy damage.